Description
Green House Feeding Short Flowering is made for plants with a short flowering time of 8 weeks or less. They need higher amounts of instantly available potassium in the early stages. This aids in growing heavier fruits and flowers in a short period of time.
Max Solubility: 1.3lb/gal or 160g/L water
Advised amount for stock solution: 4oz/gal or 30g/L water
GREEN HOUSE FEEDING SHORT FLOWERING GUARANTEED ANALYSIS
NPK: 16-6-26
| Total Nitrogen [N] | 16% |
| 11% Nitrate Nitrogen | |
| 5% Ammoniacal Nitrogen | |
| Soluble Phosphorus Pentoxide [P 2 O 5] | 6% |
| Soluble Potash Oxide [K 2 O] | 26% |
| Soluble Magnesium Oxide [Mg] | 3.3% |
| Soluble Boron [B] | 0.01% |
| Soluble Copper (as chelate from EDTA) [Cu] | 0.04% |
| Soluble Iron (as chelate from EDTA) [Fe] | 0.1% |
| Soluble Manganese (as chelate from EDTA) [Mn] | 0.05% |
| Soluble Molybdenum [Mo] | 0.01% |
| Soluble Zinc (as chelate from EDTA) [Zn] | 0.01% |
GHF Mixing Guide
How to use:
Green House Powder Feeding can be used on every medium.
However the feeding schedule is slightly different. If using anything than soil we advise using a PH- and EC-meter in order to get the desired values. This gives full control over your feeding solution.
Easy Grower
If you grow on pre fertilized soil, we advise starting using Powder Feeding 2-4 weeks after planting. Start with a mild solution (0.25g per Liter). During the veg stage you can up the feeding up to 0.5g per Liter. With the start of the flowering stage you should slowly increase the amount of Powder Feeding until you reach 1g per Liter.
Following this schedule, there should usually be no problem and growers will achieve a good yield.
Experienced Grower
Pro growers usually measure their feeding solution. This is to give the plants the exact amount of nutrients. In the same way, pH value of the solution must also be controlled.
Whether you grow in coco, hydro or aeroponics, with all of these systems you should test your pH and EC values.
When using a pH and EC meter you can optimize your growing and achieve much better results.
Used in conjunction with Grow, Calcium and Booster.
Steps of mixing nutrient solution:
- Make sure water temp is about 18-22 degrees Celsius. Test pH and EC value of the water. You should also check if your water contains enough Calcium. If your EC is 0,0 (using RO or rain water) you need to add Calcium. Do this before adding Powder Feeding. Make sure your EC rises up to 0.3-0.4 EC
- Add Powder Feeding and mix well for 2-3 minutes. Test the EC value. If needed repeat until you get to the desired value.
- When you get to the desired EC value, wait for 15-30 min.
- Then test the PH and if needed adjust it with small amounts of PH up or PH down. Mix well for 2-3 minutes and wait again 15-30 minutes before testing.
- When you get the desired values, feed your plants.
A 10 gr. dosage spoon INCLUDED in every bag!
Reviews
There are no reviews yet.