Description
Advised amount for stock solution: 4oz/gal or 30g/L water
GREEN HOUSE FEEDING BOOSTER GUARANTEED ANALYSIS
| Water Soluble Phosphorus Pentoxide [P 2 O 5] | 30% |
| Water Soluble Potassium Oxide [K 2 O] | 27% |
| Water Soluble Magnesium Oxide [Mg] | 8.2% |
| Water Soluble Boron [B] | 0.03% |
| Water Soluble Copper (as chelate from EDTA) [Cu] | 0.002% |
| Water Soluble Iron (as chelate from EDTA) [Fe] | 0.12% |
| Water Soluble Manganese (as chelate from EDTA) [Mn] | 0.05% |
| Water Soluble Molybdenum [Mo] | 0.005% |
| Soluble Zinc (as chelate from EDTA) [Zn] | 0.01% |
Green House Mineral Feeding
How to use:
Green House Powder Feeding can be used on every medium.
However the feeding schedule is slightly different and if using anything than soil we recommend using a PH- and EC-meter in order to achieve the desired values
and have full control over your feeding solution.
Easy Grower
If you grow on pre-fertilized soil we recommend starting using Powder Feeding 2-4 weeks after planting the seeds and to start with a mild solution (0.25g per Liter).
During the vegetative stage you can increase the feed- ing up to 0.5g per Liter.
With the beginning of the flowering stage you should slowly increase the amount of Powder Feeding until you reach 1g per Liter.
Following this schedule, there should usually be no problem and growers will achieve a good yield.
Experienced Grower
Experienced growers usually measure their feeding solution to provide the plants with the exact amount of nutrients and the correct pH value of the solution.
Whether you grow in coco, hydroponics or aeroponics – with all of these systems you should measure your pH and EC values.
When using a pH and EC meter you can optimize your growing and achieve much better results.
Used in conjunction with Grow, Calcium and either Long Flower, Short Flower or Hybrids.
Steps of mixing nutrient solution:
- Make sure the temp is about 18-22 degrees Celsius. Check pH and EC value of the water. You should also check if your water has enough Calcium. If your EC is 0,0 (using RO or rain water) you need to add Calcium to your water before adding Powder Feeding. Make sure your EC rises up to 0.3-0.4 EC
- Add Powder Feeding and mix well for 2-3 minutes, and then test the EC value. If needed repeat until you are at the right value.
- When you get to the right EC value, wait for 15-30 min.
- Then test the pH. If needed adjust using small amounts of PH up or PH down. Mix well for 2-3 minutes. Wait 15-30 minutes before testing pH again. Adjust of needed.
- When you are at the desired values, feed your plants.
A 10 gr. dosage spoon INCLUDED in every bag!
Reviews
There are no reviews yet.